Ocean Rodeo SLE Series, Manual

KITE MANUAL

Attaching flying lines to your 

Ocean Rodeo SLE kite.

1. 

Before you attach your lines have your kite pumped up 

leading edge down and weighted with sand or gravel.

2.

 Your SLE kite has front line attachments and two back 

line attachments supported by line bridles, locate these 
line attachment points. 
• Rear line attachment lark’s head connectors are located 
at the very tip of the leading edge tube. (1)

3.

 With the front and back attachment points free from 

their Velcro storage tabs pull the pigtails / lark’s head 
connectors forward so that the bridles are in clear view.  

Note:

 Make sure the bridles are free and clear with no 

twists and any pulleys are free and clear of debris. (2)

4. 

The rear lines connect to the kite with a foolproof 

connector that prevents the front and back lines from 
being incorrectly attached. 

5. 

Make a final inspection of your bar system. 

Important:

 If you are using an Ocean Rodeo bar with 

your SLE kite make sure your stopper is pushed away 
from the bar as far as possible. This will allow the bar to 
freely slide up the front lines and de-power the kite in the 
event of a gust during launch. 

1

2