Component replacement and adjustment procedure
7.6
Upper element substitution
1.
Disconnect the power supply cord and remove the Oven from the cabinet.
2.
Remove the rear and upper covers.
3.
Disconnect the terminals of heating element.
4.
Type A
Remove the upper element by removing two screws on the bracket,
(the screws can be
reached through the upper opening shown in figure; bend the insulating fiber, in some case it is
necessary to cut it as shown in the pic.).
Type B
Remove first the two fixing screws in the back and then the other two into the oven cavity.
5.
Extract the bad heater pulling it out from the cavity, then place the new one and secure it with
the screws
on the back side of the oven.
6.
Connect the terminals. Pay attention to the sequence of wirings and ground connections. Unbend the
insulation.
7.
The connections must not be loose.
8.
Reinstall the Oven into the cabinet.
9.
Reconnect the power supply cord after the Oven is installed.
10.
Run the Oven and check all functions.
Type A
forno da 60
Type A
forno da 60
Type B
forno da 75/90
Type B
forno da 75/90
16 di 30
