C-Nav7050 User Guide
Revision 0
Page 23 of 27
10/30/2020
Appendix B - ADL RXO UHF
Programming Procedures
This appendix provides guidance on programming the Pacific Crest ADL UHF
RXO modules. Although the modules are programmed at our Lafayette office,
there may be a time where the end user will have to add or edit frequencies and
reprogram them. This appendix assumes that the end user has a copy to
ADLCONF software (click
to download the latest ADLCONF software). The
for generic instructions on using the ADLCONF software.
The user can also contact
if they require any further assistance.
To program the UHF modules, use the following steps:
1) Connect the DB9 Serial cable from a computer terminal (that has ADLCONF)
to the
UHF Config
port.
2) Place both the
Primary Source Selector Switch
and the
Secondary
Source Selector Switch
to the UHF1 position to program the primary UHF
module, or place both the
Primary Source Selector Switch
and the
Secondary Source Selector Switch
to the
UHF2
position to program the
secondary UHF module.
3) Click on the
ADLCONF
icon on the computer.
4) Click on
Connect...,
and wait until the
Connect to ADL Radio window
Figure 9: Connect to ADL Radio Window
5) Select the correct mode, port and 9600 baud and click on
OK
.
