Sauna & Steam
Oceanic Saunas 01902 450 550 sales
@oceanic-saunas.co.uk www.oceanic-saunas.co.uk
15
Sauna Heater Manual
1800
Temperature Sensor
500
10.5. Installing the temperature sensor
i. Install the temperature sensor as in the diagram opposite
ii. Open the cover with a screwdriver
iii. Fix the bottom of the temperature sensor on to wall with screw
iv. Replace the cover.
Fig 10
Fig 11
118mm
Fig 9
10.4. Installing the controller
Control pad must be installed outside the sauna cabin. Ideally the control box should be installed
at a height of approximately 1200mm for ease of use.
Installation method:
• Drill a 40mm diameter hole through the wall.
• Pull the front off the keypad, you may find it easier with a small flat electrical screw driver.
• Pin the control cable (6 cores) to the relevant ports.
• Install the control so it sits flat on the wall. Fix using the screw holes 118mm apart.
• Put the keypad cover back on, check the cover is completely on so that all the buttons click
when pushed.