17
Ensure that the switch buttons ECO/MAX and WARM/COLD are set on
“OFF” position.
Place your device on a solid enough support to bear the weight of your
device once it’s completely full.
The product possesses 2 power inputs:
a 220-240 V ~50/60Hz power input.
a 12
power input.
Select the wanted mode (ECO/MAX and WARM/COLD)
NB : The ECO mode is not available when the cooler is supplied by the
12V power input.
NB : When the cooler is in ECO mode, it only allows to maintain the
temperature. To produce a high cooling or heating, you must switch to
the MAX mode.
NB : Do not switch suddenly between modes WARM and COLD. First,
turn off the device (OFF position) and wait for at least 30 minutes
before to switch to the opposite mode.
Open the lid and place your food and/or drinks into the storage section
of the cooler.
NB : To reach the minimize the energy consumption, we recommend
you to pre-refrigerate your food and drinks before to place them inside
the cooler to keep a better preservation of the temperature in COLD
mode.
NB : The warm mode is not intended to heat your food and drinks. It
allows you only to keep them warm.
After a few minutes, check the temperature inside the cooler. If the
correct temperature is reached, switch to ECO mode to maintain the
temperature.
If the desired temperature is not reached, switch to MAX mode.
Regularly check the temperature inside the cooler.
Place the device away from direct sun light and heating sources. The
sun light may damage the surface of the device and the heat may
increase the energy consumption. If the surrounding temperature is too
cold or too hot, it may reduce the performance of the device.
