48
flush with the outer surface of the caseback.
Returning the Module To Its Boot
1. Orient the module over the hole in the boot, and dip the bottom edge into
the hole while pressing the top edge with the palm of your hand. Stop
pressing when the bottom ridge has just entered the rubber boot
2. Correct the alignment of the module as needed so that it is straight.
3. Press the module completely into place with your thumbs, watching the
alignment, until it “snaps” into place.
Final Inspection
1. To ensure that the battery installation was successful, activate the unit
and watch carefully as it performs a full diagnostic and battery check.
Initially, the display will appear all 8's, with bar graph loading down until
the unit enters surface mode, followed by the Pre-Dive-Planning-Sequence
(PDPS). If the LOW BATT display appears and stays on, return the unit
to your Authorized Oceanic Dealer for a complete inspection before
attempting to use it.
2. Examine the LCD display to ensure it is consistently clear and sharp in
contrast throughout the screen. If there are any portions of the display
missing or appearing dim, return the unit to your Authorized Oceanic
Dealer to receive factory service.
Summary of Contents for DataMax Sport
