80
DEMO
PSI
10
20
0 5
TOO
FAST
ATR
FEET
O
2
N
2
DEMO
PSI
10
0 5
ATR
FEET
O
2
N
2
Ascending
Rate of Ascent can be set for 1 or 3 feet per seconds (fps)
prior to start of the Ascent. To change the Rate during an
Ascent, it must first be stopped.
Pressing and holding the Left (Advance) button for 2
seconds will access an Ascent Rate of 1 fps. The green
and yellow segments of the VARI and small UP Arrow
will appear with the Arrow flashing (Fig. 92).
To set the Rate at 3 fps (Too Fast), press and hold the Left
(Advance) button for 2 seconds. The red segment of the
VARI will appear together with the graphic TOO FAST
and an outer Arrow around the small one (Fig. 93). The
Alarm will sound and red LED will flash.
Pressing and holding the Left (Advance) button for 2
seconds will return the Rate to 1 fps.
Tap (press/release) the Left (Advance) button while the
Arrow is flashing to begin an Ascent at the Rate set.
Tap (press/release) the Left (Advance) button during the
Ascent to stop the Ascent.
Tap (press/release) the Left (Advance) button while the
Ascent is stopped to access Alternate displays.
Press and hold the button for 2 seconds while the Ascent
is stopped to restart the Ascent.
Pressing and holding both Buttons simultaneously for 2
seconds will revert operation to real Surface Mode.
Fig. 93 - Ascent set at 3 fps
Fig. 92 - Ascent set at 1 fps
