TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the
power cord, or the power button has been pushed off during an ice
making cycle, small ice chips may formed and lodge in the
automatic shovel causing it to jam. If this occurs, the ice chips may
be removed by disconnecting the power cord and gently pushing
the shovel to the rear of the cabinet and removing the ice chips,
then restarting.
2. Please check if the water reservoir is flat when the ice shovel can
not remove the ice to ice basket. If not, please push the ice shovel
gently by finger, then press POWER button to restart.
PROBLEM
POSSIBLE CAUSE SUGGESTED SOLUTIONS
The compressor
works abnormally with
a buzzing noise
The voltage is lower
than
recommended
Stop the ice maker and do not
restart until the voltage is normal.
Water shortage
indicator
light is on
1.There is no water
2.The pump is full of air
1.Add some water until it reaches
to MAX position
2.Press POWER button to restart
the machine
Indicator lights on
control panel are not
on
Blown fuse/ No power
Replace fuse / Turn power on
The ice made is too
large
and with pieces
sticking
together
Ice of previous cycles
left in the water tray
Take out the ice under the
standby state
24
Summary of Contents for OCEAMAG02
Page 1: ...MACHINE GLA ONS Manuel d instructions ICE MAKER Instruction manual R f OCEAMAG02...
Page 27: ......
Page 28: ......
