Plug the unit into a properly installed, properly grounded, wall outlet.
Never cut or remove (for any reason) the third (ground) wire from the
power cord. Any questions regarding power or grounding should be
directed to an accredited electrician or a center authorized to work on
this type of product.
Warning: If the grounded plug is used improperly, there may be a risk of
electric shock.
The socket of the installation must always be provided with a connection
to the ground. If the power supply is not connected to the earth; you do
not have to connect the device
It is necessary to ensure good ventilation around the refrigerator for heat
dissipation, high efficiency and low energy consumption. For this you
need to leave enough space around the refrigerator. Leave at least 10
cm of space behind and on the sides and at least 20 cm at the top. The
door must be able to open at 160 ° minimum. This product is not built-in.
Installing your freezer:
−
Place your appliance on a floor that is hard enough to hold the
appliance securely in place when it is completely filled.
−
To level the unit, adjust the feet on the front of the unit.
−
Allow a dozen inches of free space at the back and sides of the unit
so that air can circulate to cool the compressor. Also leave about
thirty centimeters above it.
−
Place the unit away from direct sunlight and heat sources (stoves,
heaters, radiators, etc ...). Direct sunlight can damage the acrylic
coating and heat sources can increase electricity consumption.
Extremely cold ambient temperatures can also cause malfunctions.
−
Avoid putting the device in humid places. If there is too much
moisture in the air, there will quickly be frost on the evaporator.
−
The product must be installed according to the national rules of
installation
−
If the power cable is damaged, it must be replaced by the
manufacturer, its after-sales service or similarly qualified persons in
order to avoid a hazard.
III. INSTALLATION
EN-1
6
