51
Connecting the hob
The connection to the power supply must be carried out in compliance with
the standards in force, or with a unipole circuit breaker. The connection
procedure is shown below.
If the cable is damaged and needs to be changed, this can only be done by
a service technician with the proper tools for safety reasons.
If the unit is directly connected to the mains supply, an omnipolar circuit
breaker must be installed, with a gap of at least 3mm between the contacts.
The installer must ensure that the electrical connections are correct and
comply with safety regulations.
The cable should not be bent or compressed.
The cable must be checked regularly and may only be changed by a qualified
professional.