Oceanic PROPLUS X, Operating Manual

52

PROPLUS X OPERATING MANUAL

© Pelagic, 2016

Doc. No. 12-5655-r01 (8/19/16)

UPLOADING/DOWNLOADING DATA

As previously described (page 13), the ProPlus X can be paired using the Bluetooth® feature. This requires a PC, Mac, or mobile device running 

Diverlog software and equipped with Bluetooth® functionality. If your personal computer is not equipped with internal Bluetooth® hardware, a 

Bluetooth® dongle can be purchased separately from a computer store. 

Alternately, The ProPlus X is configured with a data/charging connection port located on the back of the case. It can be used with the included 

adapter to connect the ProPlus X with a PC or Mac using a USB cable. Connect the adapter clip to the ProPlus X. When connecting the adapter clip 

to the ProPlus X, ensure that the adapter is connected as shown. Then connect the USB interface cable to the adapter clip. The ProPlus X and USB 

cable assembly can now be connected to a PC or Mac running Diverlog software.

   NOTE:  If a USB cable is connected to the ProPlus X, Bluetooth® connection will be blocked or disabled. Though any active down-

loads, uploads, or firmware updates using Bluetooth® will be allowed to finish first.

CARE AND CLEANING

Protect your ProPlus X from shock, excessive temperatures, exposure to chemicals, and tampering. Protect the lens against scratches with the stick on 

ProPlus X lens protector. Small scratches will naturally disappear underwater.

•  Soak and rinse the ProPlus X in fresh water at the end of each day of diving, and check to ensure that the areas around the low pressure (depth) 

sensor, PC interface data port, and buttons are free of debris or obstructions.

•  To dissolve salt crystals, use lukewarm water or a slightly acidic bath (50% white vinegar/50% fresh water). After removal from the bath, place 

the ProPlus X under gently running fresh water. Towel dry before storing.

• Keep your ProPlus X cool, dry, and protected during transport.

INSPECTIONS AND SERVICE

Your ProPlus X should be inspected annually by an Authorized Oceanic Dealer who will perform a factory prescribed function check and inspec-

tion for damage or wear. To keep the 2 year limited warranty in effect, this inspection must be completed one year after purchase (+/- 30 days). 

Oceanic recommends that you continue to have an inspection performed every year to ensure it is working properly. The costs of annual inspections, 

or inspections relating to water tight integrity, are not covered under the terms of the 2 year limited warranty.

To Obtain Service:

Take your ProPlus X to an Authorized Oceanic Dealer or send it to the nearest Oceanic Regional Facility.

To return your ProPlus X to Oceanic:

• Record all dive data in the Log and/or download the data stored in memory. All data will be erased during factory service.

• Package it using a protective cushioning material.

•  Include a legible note stating the specific reason for return, your name, address, daytime phone number, serial number(s), and a copy of your 

original sales receipt and Warranty Registration Card.

• Send freight prepaid and insured using a traceable method to the nearest Oceanic Regional Facility, or to Oceanic USA.

•  If shipping to Oceanic USA, obtain an RA (Return Authorization) number by contacting Oceanic at 510/562-0500 or send an e-mail to service@

oceanicusa.com.

• Non-warranty service must be prepaid. COD is not accepted.

• Additional information is available at the Oceanic web site OceanicWorldwide.com