STEP 5
After assembling the control module you must conduct the RESET procedure.
1) Clean the Electrolytic Cell. (see Manual page 3 )
2) Assure a good water flow trough the cell.
3) Hold the ON / MAX button and then plug the unit into the power supply.
Release the button when all green LED lights illuminates. Unit will run for a 30
second in one direction (polarity). After that it stop for 5 second and start in reverse
polarity. The RESET Procedure is completed. The production level can be adjusted
accordingly to your needs by depressing the button MIN.
Summary of Contents for SMC 20
Page 2: ...STEP 2 unplug the control board connecting cable ...
Page 3: ...STEP 3 ...
