46
MODULE REMOVAL FROM BOOT
If the Module is in a Console, bend the rubber Console Boot
back to expose the edge of the Module. If the Boot is flexible
enough to permit, you may bend it back far enough to scoop
the Module out with your finger. Otherwise, it may be neces-
sary to insert a blunt screwdriver until the tip rests just under-
neath the Module. DO NOT
pry the Module from the Console!
Slowly increase the pressure under the Module by releasing the
tension on the rubber Boot. The Module will slide up the
screwdriver and exit the Console.
If the Module is in a Wrist Boot, it will be necessary to peel the
lips of the Boot downward off the Module while applying
pressure from underneath, working it out slowly.
CAUTION: The procedure that follows must be
closely adhered to. Damage due to improper Battery
replacement is not covered by the limited 2 year
warranty.
BATTERY REPLACEMENT
The Battery Compartment should only be opened in a dry and
clean environment with extreme care taken to prevent the
entrance of moisture or dust.
R
E
S
P
O
N SIBLE
D
IV
E
R
