48
Inspection
• Closely check all of the sealing surfaces for any signs of
damage that might impair proper sealing.
• Inspect the Button, Lens, and Housing to ensure they are not
cracked or damaged.
• If it is necessary to clean the Battery Compartment, flush it
and all components with a solution of 50% white vinegar and
50% fresh water. Rinse with fresh water, and allow to dry
overnight, or blow dry with a hair dryer (set at 'no heat').
WARNING: If damage or corrosion is found, return
your Veo 100 to an Authorized Oceanic Dealer, and DO
NOT attempt to use it until it has received factory
prescribed service.
Battery Installation
• Slide a new 3 volt type CR2450 Lithium Battery, negative (-)
side down into the Battery Cavity. Slide it in from the right
side and ensure that it slides under the contact clip on the left
rim of the cavity (Fig. 49).
• Orient the Retaining Bar across the lower portion of the
Battery and carefully push it down into position (Fig. 50).
Fig. 49 - Inserting Battery
Fig. 50 -Inserting Retaining
Bar
