75
Fig. 81 - Set Demo
Calibration
Fig. 82 - Demo Surface Mode
Press and release the Right/Side (Select) button to toggle
between ON and OFF.
Press and release the Left/Front (Advance) button to accept
the setting and advance to DEMO: NI-O2 with CUR or
(NEW) flashing (Fig. 81).
When set for NEW, calculations are based on zero residual
nitrogen and oxygen loading (a clean dive). When set for
CUR, calculations take into consideration any residual
nitrogen and oxygen remaining from previous 'actual' dives.
Subsequent (repetitive) Simulated dives do not take into
consideration previous Simulated dives.
Press and release the Right/Side (Select) button to toggle
between NEW and CUR.
Press and release the Left/Front (Advance) button to accept
the setting and advance to Demo Surface Mode with the
DEMO icon flashing (Fig. 82).
Press and release the Left/Front (Advance) button to advance
to DEMO: FO2 with Air (or a numerical value) flashing (Fig.
83).
Press and release the Right/Side (Select) button to advance
the FO2 setting from AIR to 21 through 50, in increments of
1%. Max Depth for PO2 of 1.60 will be displayed.
Press and release the Left/Front (Advance) button to accept
the setting and revert to Demo Surface Mode with the DEMO
icon flashing.
Fig. 83 - Set Demo FO2
