33
VEO 4.0 OPERATING MANUAL
© Pelagic, 2019
Doc. No. 12-5671-r01 (3/20/19)
If set for Timer:
Upon ascending to 20 ft (6 m) for 1 second on any No Deco dive in which Depth exceeded 30 ft (9 m) for 1 second, a Run Timer shall appear (the
graphic TMR with Run Time counting up from 0:00 to 9:59 (min:sec) then 10 to 999 (min) will be displayed instead of a set Stop Depth/Time.
In the event that the diver descends deeper than 30 ft (9 m) for 10 seconds, the No Deco Main screen is to replace the Timer screen which is to
reappear upon ascent again to 20 ft (6 m) for 1 second.
In the event that the diver ascends above 10 ft (3 m) for 10 seconds, or enters Deco, or a High O2 alarm condition occurs (100%), while the Timer is
active, the Timer is to be disabled for the remainder of that dive.
reset timer
if stopped
start/stop
timer
ADV
SEL
SURFACING
Upon ascending to 3 ft (0.9 m) the Veo 4.0 transitions to Dive Surface mode.
NOTE: The Veo 4.0 requires a 10 minute surface interval to record a subsequent dive as a separate dive in the Log. Otherwise,
the dives will be combined and recorded as a single dive in the Veo 4.0 memory.
surface time
(hr:min)
residual
nitrogen
max depth
reached
elapsed dive
time
Summary of Contents for VEO 4.0
