22
PRESSURE TRANSMITTER
Before you dive with the VT Pro, you will need to become familiar with the interactive
features and select desired settings. The Transmitter must be installed into the High Pressure
port of your Regulator First Stage, facing to one side (Fig. 14). Oceanic strongly recom-
mends that installation be performed by an Authorized Oceanic Dealer at the time of
purchase. Instructions are provided on Page 92.
NOTE: The Transmitter is compatible with all Oceanic First Stages, but cannot
be guaranteed to fit certain models produced by other manufacturers. Check
with your Authorized Oceanic Dealer to verify compatibility with your Regula-
tor First Stage.
For the Display Module to receive a Tank Pressure signal from the Transmitter, the 2 devices
must first be Linked. The Serial Number (code) of the Transmitter must be entered as the
Link Code in the Display Module.
The Link Code is preset when shipped from the factory. To verify
the Code, refer to Page 43.
ACTIVATION
Before activating the Display Module, the regulator containing
the Transmitter must be connected to a Tank and pressurized by
slowly opening the Tank Valve. Tank Pressure of 50 PSI (3 BAR)
is required for the Transmitter to activate and send a signal.
Fig. 14 - Transmitter
mounted on First Stage
