43
Fig. 48 - Set Link Code OFF
TO SET -LINK CODE
(while in Surface Mode)
Factory set for ON and the Serial Number of the Transmitter
shipped with the Display Module, the 6 digit Code can be set for
OFF or numbers ranging from 000000 to 999999.
When set OFF, the Display Module's receiver is disabled and no
displays or calculations relating to Pressure are provided.
• Press Both buttons simultaneously, release when SET: 2
appears (4 seconds).
• Press and release the Front (Advance) button, the Units screen
appears with the set point flashing.
• Press the Front (Advance) button
19 more times
(18 more times after a dive in Digital Gauge Mode).
• The graphics
tid
and
ON
(or OFF) appear with On (or OFF)
flashing.
• Press and release the Side (Select) button to toggle between
ON and OFF.
• Press the Front (Advance) button to accept the setting. If OFF
is selected (Fig. 48), operation reverts to Surface Mode. If
ON is selected, the First digit of the Code begins to flash (Fig.
49).
• Press and release the Side (Select) button to change the First
digit.
• Press the Front (Advance) button to accept the First digit. The
Second digit begins to flash.
ATR
O
2
Fig. 49 - Set Link Code ON
ATR
O
2
