12
4.
Insert the mounting tube assembly into the hull, feeding the locking clip through first and seat into
place. Press the light hard into the hull and twist slightly to spread the sealant around behind the light to
ensure good adhesion (see image below).
Tip
: This process is made much easier if a second person is inside the hull to receive the light and install the
locking equipment whilst supporting the light from the outside. Breakages due to lights falling out of the
hull are NOT covered under warranty and can cause serious bodily injury as can any falling object.
5.
(If using Delrin sleeve) thread Delrin sleeve washer over light mounting tube until flush with the hull.
6.
Thread the washer onto the mounting tube.
Tip
: The stainless steel compression washer does not need to be flat to the hull, an undulating surface can be
taken up with the washer.
7.
Place the two C clips together to form a circle, ensuring you pair 1 threaded and 1 non-threaded hole
together. Fix clips together using one of the screws provided so that the clips are located approximately
half way down the length of the screw. Locate clips into grooves on outside of the mounting tube so
that the end of the screw is close to the washer. Fit the second screw provided into the remaining holes,
fixing the two clips together. Screw down to the same position:
8.
Tighten the locking screws using a 5mm Allen key, applying thread lock at point of thread contact with
‘C’ clip. DO NOT over-tighten locking screws, as you could damage the mounting tube and this will not
be covered under warranty.
Once you are satisfied that the unit is fully tightened, you will notice that sealant has squeezed out from around
the perimeter of the light. Using a thinner or cleaner, apply to cloth and wipe off excess sealant to leave a clean
seal. AVOID CONTACT WITH LENS. If you do not see sealant squeeze out from the body, you have not used
enough sealant or tightened the unit enough to the hull. Carefully examine the installation to make sure the seal
you have installed on the unit is fully water-tight. If in doubt, remove light, re-apply sealant and re-install.
OceanLED INSTALL / ALLURE / 240717 / 7.1
