23
160mm
106mm
414mm
Tip
: For complete instructions on V AC connections, please refer to local codes and ordinances for V AC
connections or equivalent.
Warning
: Never leave the bare cables unprotected. Water deposits in the connectors and cables will corrode
the cables causing the light to fail and will NOT be covered under warranty.
2.
Depending on the quantity of lights being installed you will need to pull the correct sized power cable
from the breaker to the driver locations to supply constant power to the units. It is imperative that the
correct sized tinned marine cable is used.
Tip
: Always use dielectric grease when making the connections to the light. Corrosion of wire is NOT covered
under warranty.
3.
Connect the Deutsch plug from the light into the Deutsch connector on the AC Power Supply (multi
pin).
4.
If you are not installing a custom fuse panel, it is imperative that the supply to each driver is
appropriately fused. Please consult electrical specification on page 4 to select the correct fuse
dependant on which model of light you have.
5
Connect the 3 core input cable end of the mains power supply to the boat’s fused power supply using
waterproof connectors or waterproof junction box. (Brown is Live, BLUE is Neutral, GREEN/YELLOW is
Earth).
6.
Continue to section 5.5 for DMX connection.
5.5
DMX Control Connection
TIP:
It is recommended to mount drivers within 10’/3m of one another in order to utilise the 3m DMX
Ethernet Colours Connection Cable provided.
Warning
:
Never leave the bare cables unprotected. Water deposits in the connectors and cables will corrode
the cables causing the light to fail and will NOT be covered under warranty.
1.
Using the DMX cable (supplied with the OceanLED DMX controllers), connect the first driver in the
series into the first DMX port. If required, the DMX control panel cable can be extended by a competent
electrician.
2.
If you have multiple drivers, they have to be daisy-chained; DMX out (driver 1) to DMX IN (driver 2) – See
diagram below.
3.
The final device in the chain needs to be terminated properly using a DMX terminator. This is essential
for closing the control circuit (Included with OceanLED DMX controller kits).
OceanLED INSTALL / ALLURE / 240717 / 7.1
