EXPLORE
E2
.
INSTALL & OPERATION MANUAL
15
5.4 LIGHT CARTRIDGE RE-INSTALLATION
Additional items required not supplied by OceanLED:
•
Isopropyl Alcohol (IPA)
Before installing the light cartridge, clean the inside of the mounting tube with Isopropyl Alcohol (IPA) cleaner
and let it dry. Failure to do this may introduce potential contaminants that may damage the product and void
your warranty.
Lubricant substances of any kind MUST NEVER be used to ease the insertion of the light cartridge into the
mounting tube as this will damage the light and void the warranty. Should any help to insert the light cartridge
be needed, OceanLED recommend the use of a small quantity of Isopropyl Alcohol sprayed onto the O-Ring
on the back of the light cartridge.
1. Inspect the mounting tube and light cartridge to ensure no contaminant (grease, debris, dirt) and/or water are
present.
2. Undo the cable gland to act as a breather. Failure to do so will make the installation process significantly harder
and could damage the light and void the warranty.
3. Align the light cartridge with the mounting tube. Push the light cartridge in slowly until it bottoms out against the
front bezel. Please see
Chapter 4 Installation.
4. Tighten the cable gland.
5. Fit the Locking Ring.
6. Connect the power cable and test the light. Re-check if the light is pointing the right way up.
