EXPLORE
E7
2 0 1 9 I N S T A L L & O P E R A T I O N M A N U A L
17
3.6 TEST YOUR INSTALLATION
Always test the lights
BEFORE
the vessel goes back into the water. At this final stage make sure all of the system is
operational. If you have any issues, please contact your local OceanLED representative.
Never install a new light fixture then leave the vessel in the water unchecked for several days.
When the vessel is placed in the water, immediately check for leaks. Note that very small leaks may not be readily
observed. It is best not to leave the vessel in the water for more than 3 hours before checking it again. If there is a small
leak, there may be considerable bilge water accumulation after 24 hours. If a leak is observed, you must
TAKE ACTION
IMMEDIATELY
to prevent damage.
