EXPLORE
E7
2 0 1 9 I N S T A L L & O P E R A T I O N M A N U A L
21
4.4 LIGHT CARTRIDGE INSTALLATION
Additional Tools needed that are not supplied by OceanLED
Allen
Key
(2mm)
Before installing the light cartridge, clean the inside of the mounting tube with isopropyl alcohol cleaner and
let it dry. Failure to do this may introduce potential contaminants that may damage the product.
Lubricant substances of any kind MUST NEVER be used to ease the insertion of the light cartridge into the
mounting tube. Should any help to insert the light cartridge be needed OceanLED recommend the use of a
small quantity of Isopropyl Alcohol sprayed onto the O-Ring on the back of the light cartridge.
1. Inspect the mounting tube and light cartridge to ensure no contaminant (grease, debris, dirt) are present.
2. Using the 2mm Allen key, remove one of the screws on the back of the light cartridge to act as a breather.
Failure to do so will make the installation process significantly harder.
3. Align the light cartridge with the mounting tube. Push the light cartridge in slowly until it bottoms against the
front bezel.
Vertically align the light before fully inserting it to the mounting tube. Failure to do so will force you to remove
the light cartridge. Make sure that the LED Indicator is at the top and central on the back of the light cartridge
or aligned as per OceanLED custom alignment instructions.
4. Re-install the screw using a 2mm Allen key (hexagonal key). Re-install the locking screw making sure it is
bottomed out against the light cartridge.
5. Connect the power cable and test the light. Re-check the light is oriented correctly.
