EXPLORE
E3
.
2021 INSTALL & OPERATION MANUAL
16
5
Operation / Maintenance
5.1 SINGLE COLOUR STROBE
To enter strobe mode, toggle the power on and off quickly twice and then back on. They should now strobe in a pseudo-
random pattern. The lights can be reset from strobe mode after 20 seconds of use. Simply turn off then turn on again.
5.2 DUAL COLOUR OPERATION
Dual Colour Operating Modes:
The Dual colour change has seven modes of operation:
1. Single colour white
– this mode is entered when first turned on.
2. Single colour blue
3. Fade = Fade between white and blue
4. Random white strobe
5. Random blue strobe
6. Alternate blue/white strobe
7. Dual colour (both white and blue on)
To switch between modes, turn off power to the light(s) for less than 1 second, then back on again.
Please note: Fade mode is not guaranteed to stay in sync between lights over time.
Dual Colour Configuration Mode
Description: Enables selection of either white or blue colour as default at power up.
To enter configuration mode:
1. Turn on light(s)
2. Wait around 1 second (or until light(s) illuminate)
3. Turn off light(s)
4. Wait for a minimum of 5 seconds then turn light(s) back on again.
5. Repeat steps 2-4 another 4 times. (If the light changes mode on re power up then the light has not been turned
off for long enough in step 4)
6. On the 5th power up, the light(s) should enter the configuration mode
– this will be confirmed with a sequence
of five blue/white flashes followed by a steady white (the steady colour indicates the default start up colour).
Setting the default start up colour
1. Once the configuration mode has been entered (see above). Toggling off the power and back on again quickly
(as in a normal mode change) will toggle between the default start-up colours (blue & white). This is indicated
by the colour displayed after the blue/white flash sequence.
2. To save the selected state simply turn off the light(s) when the required start up colour is displayed and wait
for 5-10 seconds.
3. The light(s) should now be configured to start with the selected colour as default.
