EXPLORE
E3
.
2021 INSTALL & OPERATION MANUAL
7
Installation (Once hull preparation is complete)
1. Test light(s) before fitting.
2. If using a Delrin Isolation Kit, insert the Isolation Kit front washer into the drilled hole and apply marine sealant to
seal between the Front Washer and the hull.
3. Apply sealant to the rear of the mounting tube
assembly’s bezel to ensure a complete unbroken seal around
the light.
Make sure sealant fills in the recess groove on the reverse of the light bezel:
4. Insert the complete light unit (mounting tube as light cartridge) into the hull, pressing the light hard
into the hull and twist slightly to spread the sealant around behind the light to ensure good adhesion.
5. Ensure the light orientation is correct with the red arrow sticker on the rear lid pointing up perpendicular
to the waterline.
Sealant
