4. Finalize your OceanLED installation
Test your lights
Always test the lights BEFORE the boat goes back into the water. Failure to test
prior to launch may require boat to re hauled out. At this final stage make sure
all of the system is operational (see online manual). If you have any issues, please
contact your local OceanLED representative.
Warning:
Never install a new light and leave the boat in the water unchecked for
several days.
When the boat is placed in the water, immediately check for leaks. Note that very
small leaks may not be readily observed. It is best not to leave the boat in the
water for more than 3 hours before checking it again. If there is a small leak, there
may be considerable bilge water accumulation after 24 hours. If a leak is observed
you must take action immediately to prevent damage to the property.
5. Operation
Single Colour Strobe
To enter strobe mode, toggle the power on and off quickly twice, then back on.
They should now strobe in a pseudo-random pattern. The lights can be reset from
strobe mode after 20 seconds of use. Simply turn off then back on again.
Dual Colour Operation
The Dual colour change has seven modes of operation;
1.
Single colour white – this mode is entered when the light is first turned on.
2.
Single colour blue
3.
Fade - Fade between white and blue.
4.
Random white strobe -
5.
Random blue strobe -
6.
Alternate blue/white strobe
7.
Dual colour (blue and white both on)
To cycle between the above modes, turn off the light for less than 1 second, then
back on again.
PLEASE NOTE:
Fade mode is not guaranteed to stay in sync between lights over
time.
To change default start up colour, please see full manual for configuration mode
www.oceanled.com
