10
12/24V DC
Connection Diagram
FUSE/BREAKER
(NOT SUPPLIED)
FUSE
FUSE
POWER SWITCH
(NOT SUPPLIED)
FUSE
RED
BLACK
SPORT
S3116s
2.4 - Finalize your OceanLED installation
Test your lights
Always test the lights BEFORE the boat goes back into the water. Failure to test prior to launch may
require boat to re hauled out. At this final stage make sure all of the system is operational. See Chapter 3
Operation. If you have any issues, please contact your local OceanLED representative.
Warning:
Never install a new light and leave the boat in the water unchecked for several days.
When the boat is placed in the water, immediately check for leaks. Note that very small leaks may not
be readily observed. It is best not to leave the boat in the water for more than 3 hours before checking it
again. If there is a small leak, there may be considerable bilge water accumulation after 24 hours. If a leak is
observed you must take action immediately to prevent damage to the property.
