SPORTS SERIES
DOCKLIGHT
.
INSTALL & OPERATION MANUAL
16
4.3 SPORT MULTI COLOUR CONTROL WITH DC SWITCH OPERATION
The Sport Multi Colour has three modes of operation, single colour mode, cycle / programming mode, and
strobe mode:
1. Single colour mode
– this mode is entered when the light is first turned on. The light will be a single colour, either
a default white, or a previously selected colour.
2. Strobe mode
– to enter this mode, turn off the light for less than 1 second, then back on again. The light will flash
in a pseudo-random pattern - the colour will be the same as that in single colour mode.
3. Cycle / Program mode, to enter this toggle the power to the unit off twice for less than 1 second each time. The
light will then slowly cycle and fade through the colour spectrum (see diagram below for cycle order). It can be
left in cycling if required, or alternatively, once the light shows the desired colour this can be stored by switching
the light off for more than 2 seconds. When the light is switched back on it will be back in single colour mode,
displaying the previously selected colour.
NOTE:
If during the above operations, one or more lights connected go out of sync, simply switch off
the lights for more than 2 seconds, then re-enter cycle mode to re-select the colour.
3.1
SPORT MULTI COLOUR CYCLE
Blue ----> White ---
–> Green ---–> Blue ---–> Red ---–> Green (then repeat).
4.4 MAINTENANCE
Sea growth can collect quickly on the light and this can reduce the performance in just a few weeks. To prevent the
build-up of sea growth, all OceanLED lights have been coated with a specialized Tritonium coating which makes the
surface of the lens a non-stick layer which helps ward off long term barnacle buildup.
Lights should be cleaned with a boat brush or similar biweekly or as needed to keep the lens of the light clear. Growth
varies greatly around the world and maintenance is imperative to the proper operation and longevity of the product. If
heavy fouling occurs, barnacles can be removed from the lens using a plastic scraper and moderate pressure. This
can be done in the water using a plastic scraper. If out of water, moisten the growth before wiping.
Harsh cleaning solvents will damage the light and Tritonium coating. Never clean lights using a high-pressure
jet wash
– this will invalidate warranty. Failure to do so will invalidate your warranty.
4.5 REPLACEMENT PARTS
The light source of this luminaire is not replaceable; when the light source reached its end of the life the whole luminaire
shall be replaced.
Lost, broken and worn parts can be replaced on request and can be obtained through your local OceanLED
representative. If the external flexible cable of this unit is damaged, contact your local OceanLED representative to
arrange for replacement (cable must only be replaced by OceanLED, service agent or a similar qualified person).
