SPORTS SERIES
DOCKLIGHT
.
INSTALL & OPERATION MANUAL
3
DANGER
RISK OF ELECTRIC SHOCK OR ELECTROCUTION
This underwater light must be installed by a licensed or certified electrician in accordance with all applicable
local codes and ordinances. Improper installation will create an electrical hazard which could result in death
or serious injury to swimmers, installers, or others due to electrical shock, and may also cause damage to
property. Always disconnect the power to the light at the circuit breaker before servicing the light. Failure to
do so could result in death or serious injury to serviceman, swimmers or others due to electrical shock.
PRETEST
Always test the lights prior to installation. Failure to do this may result in additional installation time and could invalidate
the warranty.
GENERAL
OceanLED underwater dock lights are generally used for illuminating the waters around marinas and waterways. Best
placement for achieving the best results are described in selecting the right location.
IMPORTANT NOTICE
Attention Installer:
This manual contains important information about the installation, operation, and safe use of this
product. This information should be given to the owner and/ or operator of this equipment.
WARRANTY COVERAGE
for full warranty statement.
1
Installation Checklist
1.
Decide on light spacing
– OceanLED recommendations available.
2.
Ensure correct cable gauge is used (refer to relevant cable gauge chart).
3.
Make sure the lights have been fitted following the correct orientation.
4.
Never leave lights unchecked for a few days after install.
Always check routinely for a few days after installation to ensure the install is correct and fully
sealed.
5.
Test installation BEFORE entering water. Never connect/ disconnect lights whilst powered ON.
6.
Troubleshooting if required - most issues can be resolved by following the guidelines.
