SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
9
Installation (Once hull preparation is complete)
If installing an Isolating kit, please refer to the supplied instructions.
1. Test light(s) before fitting. Before proceeding with the fitting of the light(s), it is essential to test them to ensure their
functionality. Testing the lights before installation allows you to verify that they are in proper working condition and
producing the desired illumination. Once the lights have been tested and confirmed to be in good working condition,
they can be safely fitted onto the hull.
2. Apply a generous amount of the chosen sealant to the back perimeter of the light body
①
. Ensure that the cable
of the light is thoroughly coated where it meets the back of the light
②
. There should be a continuous and
unbroken bead of sealant around the perimeter of the light unit, including the screw holes and cable exit. When
applying sealant to light fixture, be careful to protect the lens from any abrasive surface/floor so as not to remove
the protective Tritonium coating.
3. Insert the light on to the hull, feeding the cable through first, and then seat it into place. Press the light firmly onto
the hull to ensure a secure and adhesive attachment.
4. To ensure proper dispersion of light underwater, make sure all Sport Lights are mounted with the correct orientation,
with the logo
③
facing upwards.
5. Cover the screw
④
threads with the sealant and screw into the pre-drilled pilot holes.
6. Tighten the screws
④
with a hand tool ONLY!
7. Once you are satisfied that the unit is fully tightened, you will notice that sealant has squeezed out from around the
perimeter of the light. Using a thinner or cleaner, apply to cloth and wipe off excess sealant to leave a clean seal.
AVOID CONTACT WITH LENS. If you do not see sealant squeezing out from the body, it means you haven't used
enough sealant or haven't tightened the unit enough to the hull. Carefully examine the installation to ensure that
the sealant you have applied to the unit is completely watertight. If you have any doubts, remove the light, re-apply
the sealant, and then reinstall it.
①
②
④
③
