SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
21
5
Troubleshooting
5.1 TROUBLESHOOTING PROBLEMS AND THEIR SOLUTIONS
SPORT Series
PROBLEM
CHECK
CAUSE
FIX
Light does not
look bright.
Check that there is no marine growth
on the lens.
Marine growth.
Clean the lens as per maintenance
advice.
Check voltage supply to the light is
between 11V and 32V DC (The light
will still work between 10 and 11 volts
however at reduced brightness).
Voltage is either too
high or too low.
Investigate reason for high or low
voltage and fix.
Check voltage supply is stable and
does not fluctuate.
Voltage is fluctuating.
Investigate reason for voltage
fluctuation and fix.
Check that the electrical connections
between the light and the supply
cable have been made correctly and
recommended cable gauge has been
used.
Poor electrical
connection.
Remake connection and seal joint
correctly.
Confirm all LEDs are illuminated.
1 or more LEDs are
not working.
Contact your dealer.
Check lights to see if water is present
inside the light.
Water present.
Contact your dealer.
Check cable connections for
corrosion.
Corrosion is present.
Contact your dealer for a
replacement. This is NOT covered by
the warranty.
Light does not
light up.
Check that there is power supplied to
the light cable connection.
Poor electrical
connection.
Trace the cables back, checking at
joints until break has been located.
Check that the wiring polarity is
correct, red to positive and black to
negative.
Polarity incorrect.
Change the wiring polarity and seal
joint correctly.
Check that there is power supplied to
the light cable connection.
Replace fuse.
If fuse keeps blowing, then there is
short circuit in the light system that
must be traced and rectified. If no
external short can be located contact
your local OceanLED representative.
