SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
30
OceanLED SPORT DMX Colours Connections:
Light 1 / Light 2
Wire colour
+VE
RED
GND
BLACK
DMX+
YELLOW
DMX-
BROWN
5.
Loosen the “Light 2” M16 cable gland cap
⑤
and feed the cable of the second light through the gland and
into the screw terminal
⑥
in the correct order. Use a flat-head screwdriver to tighten the screws on the
screw terminal and secure the cable gland.
6. Loosen the DMX In cable gland cap
⑦,
pass the DMX cable through the gland, and connect it to the DMX In
screw terminal
⑧
in the correct order. Tighten the screws and secure the cable gland.
OceanLED DMX Link Cable connections:
Light 1 / Light 2
Wire colour
GND
BLACK
DMX+
YELLOW
DMX-
BROWN
SHIELD
SCREEN
Not Connected
RED
7. If only one DMX Junction Box is being used, switch on the DMX terminator
⑫
and seal the DMX Out cable
gland with a blanking plug (not provided). Proceed to step 8.
8. If multiple boxes will be used, loosen the DMX Out cable gland cap
⑨
, pass the DMX Link cable through the
gland, and connect it to the DMX Out screw terminal
⑩
in the correct order. Tighten the screws and secure
the cable gland. Keep the DMX terminator
⑫
off, but switch on the terminator
⑫
in the final Junction Box in
the chain.
9. Ensure that the appropriate value fuses are installed for each output
⑪
. The supplied fuses are rated 7.5
Amps. Refer to the corresponding light manual for the required fuse values. (Note: The required fuse type is
mini-blade.)
10. Close the lid of the junction box and secure it using the provided four screws. Seal any unused cable glands
with a blanking plugs (not provided).
11. Repeat the procedure for next Junction Box.
Note: Before closing the junction box and supplying power to the lights, please double-check all connections
to ensure their accuracy
. Test the whole system BEFORE the boat goes back into the water.
