SPORTS SERIES
Single / Dual / Colours / DMX
.
INSTALL & OPERATION MANUAL
8
3.2 INSTALLING THE LIGHT FIXTURE
If using the Isolating kit, please refer to the instructions provided with the kit.
OceanLED recommends use of provided screws: No.6 (3.5mm) x 1 inch (25mm) Pozi Self Tapping Pan Head
Screws - Stainless Steel. If alternative screws are used, do not use counter sunk or non-flat shoulder screws
to secure your lights to the hull (failure to do so will invalidate your warranty).
Please check all components prior to installation. If there is any damage to connectors, cables, and/ or any
other component, please notify OceanLED BEFORE installation. Failure to notify OceanLED of damage in
transit prior to installation will lead to violation of warranty.
OceanLED recommends dry fitting all products. Before applying sealant, please ensure the surface is clean
of any dust, dirt or grease. When installing, be sure that the light fits the area and secures to the hull using
the appropriate hardware before applying any sealant.
Light is for mounting directly to a flat surface on the hull, with the cable passing through a 1/2" (12.5mm) hole
in the hull. Do not submerse your cable ends in water; cable and connections exposed to under-water
submersion will not be covered by warranty. Mounting the light in any other configuration, other than those
described in this guide, will invalidate its warranty.
Never use power tools to secure your lights; hand tighten only.
Do not use any un-authorised cleaning products to remove excess paint or antifoul off the front face of the
light unit. OceanLED recommends using Isopropyl Alcohol (IPA) only.
Never install a new light fixture then leave in the water unchecked for several days.
Installation Overview:
Figure 1 Exploded view of the Sport underwater light assembly (without Isolating kit)
