X-SERIES
X4 / X8 / X16
.
INSTALL & OPERATION MANUAL
15
4.4 FINALISING THE INSTALLATION
The X Series body is constructed from chemically resistant optical polymer and does not require further protection. The
lens is pre-coated with a specialized Tritonium® coating which makes the surface of the lens a non-stick layer.
OceanLED does not recommend that bottom paint or any type of anti-fouling agent is applied to the light body
apart from the front bezel, as damage may occur due to chemical incompatibility.
4.5 TEST YOUR INSTALLATION
Always test the lights
BEFORE
the vessel goes back into the water. At this final stage make sure all of the system is
operational. If you have any issues, please contact your local OceanLED representative.
Never install a new light fixture then leave the vessel in the water unchecked for several days.
When the vessel is placed in the water, immediately check for leaks. Note that very small leaks may not be
readily observed. It is best not to leave the vessel in the water for more than 3 hours before checking it again.
If there is a small leak, there may be considerable bilge water accumulation after 24 hours. If a leak is
observed, you must TAKE ACTION IMMEDIATELY to prevent damage.
