10
3.
If you are not installing a custom fuse panel, it is imperative that the OceanLED supplied fuse is
installed on each power line from each light. Please consult electrical specification on page 4 to
select the correct fuse.
4.
Secure wiring using cable ties ensuring where the cable exits the light it is not under undue stress.
2.4 - Finalize your OceanLED installation
Test your lights
Always test the lights BEFORE the boat goes back into the water. Failure to test prior to launch may require
boat to be re hauled out. At this final stage make sure all of the system is operational (see chapter 3). If you
have any issues, please contact your local OceanLED representative.
Warning:
Never install a new light and leave the boat in the water unchecked for several days.
When the boat is placed in the water, immediately check for leaks. Note that very small leaks may not
be readily observed. It is best not to leave the boat in the water for more than 3 hours before checking it
again. If there is a small leak, there may be considerable bilge water accumulation after 24 hours. If a leak is
observed you must take action immediately to prevent damage to the property.
O RING
BARE ENDS
8MM MAX
TERMINAL
TERMINAL
SCREW
TERMINAL
SCREW
TERMINAL
SPRING
FUSE
5X20MM
CUT HERE
2>2.7MM (.079>.106”)
CABLE
cable gauge 14awg
CUT HERE
1.5>1.9MM (.059>.075”)
CABLE
cable gauge 16awg
CUT HERE
1>1.4mm (.040>.055”)
CABLE
cable gauge 18awg
