Document UT-MT-0428
Page 10 of 35
Edition 11/03/2014
Supersedes edition 04/30/2012
INSET RUNWAY EDGE LIGHT SLRE
INSTRUCTION MANUAL FOR USE, INSTALLATION AND MAINTENANCE
Watertightness between fixture and shallow base is ensured by means of an O-Ring
(separately supplied) to be placed on the relevant groove around the lower cover.
The fixture is supplied with one or two
cable leads with L-823 plug
; each of them
consists of two single-pole teflon leads, size 2.1 mm
2
(#14 AWG), 0.700 m long. The
plug is in compliance with FAA AC 150/5345-26 for very quick coupling with the
receptacle mounted on the shallow base.
The fixture is 304 mm in diameter and 123 mm (+ 18,5 mm for plugs) high; the
protrusion above the ground is less than 12.7 mm.
An identification data label is externally applied over the lower cover (Figure 1 -
n°30). Moreover, to identify quickly the beam colour, the letters “A”, “B” and “C” of
the dome in front of the windows are painted in the same colour of the light beam.
The same colour painting is provided outside on the lower cover.
See
“Complete P/N identification”
figure for P/N information.
All hardware is made of stainless steel.
Figure 1 – Sectional View
