Ochsner 288800V, Design And Installation Manual

6  

www.ochsner.com  |  PIA-982027-AIR 85-sh-EN  

Safety

2.  Safety

2.1  Intended use

The appliance is intended for use in a domestic environ-

ment. It can safely be used by people who have received 

no instruction. The appliance can similarly be used in a 

non-domestic environment such as commercial premises, 

as long as it is used in the same intended manner.

Any use of the appliance that is different from or goes 

beyond this is not regarded as intended use. Intended use 

also includes observing this documentation and the docu-

mentation for operation and any accessories used.

2.2  General safety information

Observe the following safety information and instructions 

for the appliance.

►

Only qualified contractors should carry out the elec

-

trical work and installation of this appliance. Only 

qualified contractors may open the appliance.

►

Commissioning of the appliance may be carried out 

only by OCHSNER Customer Service or by customer 

service partners authorised by OCHSNER.

►

The qualified contractor is responsible for compliance 

with all relevant regulations during installation and 

commissioning.

►

Only operate the appliance when it is fully installed 

and with all safety devices fitted.

►

Protect the appliance from dust and dirt ingress dur-

ing building work.

►

Alterations to the appliance may only be carried out 

by OCHSNER Customer Service or by customer ser-

vice partners authorised by OCHSNER.

►

Functions to protect the heat pump can be enabled 

using the controller. However, since the controller 

is not certified as a safety device, safety measures 

in case of breakdown or damage to the heat pump 

(e.g. additional external switching of the safety devic-

es in use) must comply with local regulations. In the 

case of upgrades or updates to the controller soft-

ware, all function parameters of the heat pump must 

be checked.

►

Before commencing electrical connection and instal-

lation work, the heat pump system must be isolated 

from the power supply.

►

The appliance must not be used as a step or plat-

form. Do not climb on the appliance or place any 

loads on it.

►

The appliance may be used by children aged 8 and 

up and people with reduced physical, sensory or 

mental capabilities or a lack of experience provided 

that they are supervised or that they have been in-

structed on how to use the appliance safely and have 

understood the possible risks. Children must not be 

allowed to play with the appliance. Children must not 

be allowed to clean or carry out user maintenance on 

the appliance without supervision.

►

The controller, auxiliary modules, plug-in strips and 

controller cables can also be supplied with voltage by 

means of external switching (safety cut-out devices, 

etc.), if the controller is not connected or no mains 

voltage is present at the controller.

►

The heat pump has no separate ON/OFF switch. In 

an emergency, the system must be shut down via the 

specified safety devices.

►

If the system has obvious damage, makes a noticea-

ble noise or emits smoke, switch off the system and 

contact OCHSNER Customer Service immediately.

►

Contact with refrigerant can cause serious injuries.

 - In the event of a leak, avoid contact with the 

refrigerant.

 - Bear in mind that refrigerant can be odourless.

►

In the event of a fault, refrigerant could enter the 

working area through the heat sink system.

 -

Do not use an open flame within 20 cm of the 

quick-action air vent valve and the safety valve 

outlet. 

 - Ventilate the installation room well when enter-

ing it.