6.5 Unpairing the remote control (Bluetooth mode)
When you replace the remote control with a new one or reset the paired remote
control to the factory settings, you have to unpair the remote control from the set-
top box.
1. In the user interface of the IPTV system, go to the
Settings > Remote control
screen or press the button on the set-top box.
2. Follow the instructions to unpair the remote control.
The set-top box restarts.
The screen for pairing the remote control is shown.
3. Follow the instructions to pair the remote control.
6.6 Resetting the remote control
When you reset the remote control to the factory settings, you also have to
unpair the remote control from the set-top box (see Section "Unpairing the
remote control (Bluetooth mode)" on page 16). Only then can you pair a
remote control with the set-top box again (see Section "Pairing the remote
To reset the remote control to the factory settings, proceed as follows:
1. Press and hold down the red and blue function buttons simultaneously for at
least 5 seconds.
The green LED on the remote control flashes twice in quick succession.
2. Enter the digits
9999
.
If the green LED flashes twice in quick succession, the remote control has
been reset to the factory settings.
The remote control is in Bluetooth mode. The Bluetooth connection to the set-top
box and the programmed TV code (if any) have been erased.
16 | P580 Hybrid CM
