26
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 2 - Technical specifi cations and layout
2.5.2
COMPUTER CONTROLS
56
57
58
59
54
55
53
60
61
63
Ref.
Description
Function
53
Power button
It switches the computer on. It has two positions, ON and OFF.
54
Cycle start button
It starts the raingun's working cycle: START.
55
Cycle stop button
It stops the raingun's working cycle: STOP.
56
+ Button (▲)
It is used to increase numerical values, which are fl ashing.
57
– Button (▼)
It is used to decrease numerical values, which are fl ashing.
58
Programming (PROG)
The PROG button is used to enter the programming menus and to confi rm selections.
59
Manual function
It has the purpose of manually controlling the turbine by-pass and adjusting the machine's
work speed through the buttons:
+ INCREASE
- DECREASE
60
Pressure switch (as option for Aqua System )
It is used to send the 'pressure on' signal to the computer.
61
Inductive sensor for metre counter
Used by the computer to detect the unwound metres of hose.
62
End stroke micro-switch (only available with
computer Rain Control only for R1AT15 )
It sends the electrical signal to the computer when the machine's work is over.
63
Modem for GSM (only available with
computer Rain Control only for R1AT15 )
It is used to remotely monitor the machine's operating status with a mobile phone.
62
Summary of Contents for MR
Page 99: ......