32
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 4 - Safety
4.1.2
DIRECTIVES APPLIED AND TECHNICAL STANDARDS OF REFERENCE
The machine has been designed, constructed and tested complying with the following EC directives:
•
Machine Directive 2006/42/EC concerning approximation of the laws of Member States relating to machinery.
•
EMC Directive 2004/108/EC.
•
Directive 2000/14/CE (Legislative Decree 262/2002) and Directive 2005/88/EC on Noise Emissions in the environment by machines and
equipment for outdoor use. (procedure as per Annex V – Item 2) (Only for models with internal combustion engine).
•
Technical standards listed in the declaration of conformity.
4.1.3
CERTIFICATION OF THE MACHINE
Directive 2006/42/EC states the conditions according to which the machine may be marketed in the European Union.
The machine supplied by the Manufacturer does not fall within one of the categories of machines listed under Annex IV of Directive 2006/42/EC, hence
for the aims of certifying conformity of the machine to the provisions of said directive the Manufacturer applies the conformity assessment procedure
with internal inspection on machine construction as per annex VIII of Directive 2006/42/EC.
In order to certify the machine's conformity to the provisions of the Directive, before placing the machine on the market the Manufacturer performed a
risk assessment with the aim of assessing compliance with the essential health and safety requirements set forth in Directive 2006/42/EC, as well as
the tests and inspections set forth by the applicable standards of reference.
The technical construction
fi le has been prepared complying with the provisions of annex VII of Directive 2006/42/EC and is available for inspection
by the supervisory bodies upon substantiated request, as provided for by applicable laws in force.
The Manufacturer therefore markets the machine providing it with the following adjuncts:
•
CE Marking
•
CE Declaration of Conformity
•
Instruction and warning manual
The machine always features identifi cation plate “ A “ which is visibile on the side of the traveller near the tow bar.
CE MARKING DESCRIPTION:
1. Manufacturer's company name and address
2. CE mark proving conformity to Directive 2006/42/EC
3. Type
4. Serial number
5. Year of construction
6. Overall unladen machine weight
7. Overall weight of the machine fi lled with water
Below is a facsimile of the identifi cation plate displayed on the machine.
MR-MR/1
MRR-R1AT15
“ A “
The machine marking complies with the provisions of EN 908, specifi cally, in addition to the above information, the following is also provided:
•
The controls for adjusting the circle sector of the long range raingun rotating part are clearly marked and identifi ed;
•
A warning has been installed on the raingun trolley to alert to the risk of contact between the water jet and aerial power lines.
Below are facsimiles of the Declaration of Conformity without internal combustion engine and with internal combustion engine.
Summary of Contents for MR
Page 99: ......
