54
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 5 - Installation
CAUTION
Always check the hose before lifting since the machine weight might vary depending on whether it is full or empty, therefore refer
to paragraph 2.4.1 for increased safety.
•
Never climb on the machine or on the raingun trolley, whether stationary or moving.
•
Never use the machine or the raingun trolley as a means to climb to higher positions
Before starting handling operations of the machine and its structure:
•
remove protective covers and packaging (if present);
•
remove any fastening tie downs used for transport;
•
ensure the ground/surface of the site selected for placement is even, level and can withstand the weight
specifi cations of the machine set out in
paragraph 2.4.1.
Always perform pre-lifting by a few centimetres to check the correctness and safety of the sling as well as to balance the load.
After performing the actions set out above, you may proceed with lifting for placement, ensuring the base remains level during lifting and is not subject
to swinging or unbalancing.
After perfect balancing is achieved you may proceed with load lifting and handling and subsequent placement in the proper position.
CAUTION
In the event the operator's visibility is obstructed by the overall dimensions and/or operating situation, signal personnel must be
required to stand outside the operating range of the lifting equipment.
DANGER
Never walk or drive under suspended loads, never handle the load above personnel operating at the site.
DANGER
Should it be required to operate on higher machine parts, operators must pay the utmost attention and use adequate lifting
systems and personal protection equipment to avert the risk of falling.
CAUTION
Unloading, handling, lifting, etc. of the structure and machine must not be carried out in the event of adverse atmospheric
conditions (such as wind exceeding 0.3 m/minute).
CAUTION
Dispose of packaging materials in compliance with the regulations in force in the country of installation.
Disposal of packaging materials is the responsibility of the customer.
MRR-R1AT15
Summary of Contents for MR
Page 99: ......