58
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 6 - Use and Operation
6
USE AND OPERATION - GENERAL INFORMATION
This chapter has the purpose of providing information required by the customer/buyer for correctly using and operating the machine.
Additional detailed information is provided in the documentation attached to this manual (chapter 9).
CAUTION: ONLY OPERATE IF
The principles concerning safe use of the machine set out in this instruction and warning manual have been learnt and
implemented.
Avoid hazardous situations. Learn and understand safety regulations before moving to the following sections. In particular, it is
strictly required to:
Always perform a preoperative visual inspection.
Always perform functional tests prior to use.
Inspect the work area.
Only use the machine for the uses it has been designed for.
This manual has been read and the following regulations have been complied with:
•
employer safety rules and regulations of the place of operation.
•
applicable law provisions.
You are properly trained to be able to operate safely.
CAUTION: SAFETY FEATURES
Ensure all protection devices and guards are in their proper position. If protection devices and guards are damaged, they must
be repaired and/or replaced. Correctly use the safety systems and devices the machine is equipped with.
Never remove or tamper with any protection/safety system and/or device.
It is indispensable for them to be maintained in a good operating condition in order to correctly perform their function.
Improper use of safety systems and devices may cause serious injury or death.
CAUTION: PPE REQUIRED TO OPERATE THE MACHINE
Every operator's undivided attention is required to operate the machine safely.
Always wear the statutory personal protection equipment listed
below:
•
Ear protectors
•
Protective gloves
•
Safety shoes
•
Protective overalls
6.1
PROFESSIONAL PROFILES AND MANDATORY PPE
Below is a list of professional profi les and related PPE required for the installation stage.
Personal protection equipment for the operator as set out above.
Personal protection equipment for the operator as set out above.
6.2
CHECK PRIOR TO STARTING WORK
6.2.1
PREOPERATIVE INSPECTION
It is the operator's responsibility to perform a preoperative inspection.
This visual inspection must be performed by the operator before each new work shift and prior to starting up the machine. The inspection has the
purpose of uncovering any fault or damage of the machine.
A damaged machine must never be used. Should any damage or change be detected with respect to the initial standard conditions, the machine must
be marked out and put out of service for the required repairs.
When the repairs have been performed, the operator must again perform a preoperative inspection and must perform functional tests prior to using
the machine.
Please refer to the following list and check each listed element and/or part:
1. Ensure the use and maintenance manual is complete, legible and is in the suitable document holder box on the machine.
2. Ensure all the warning and danger decals / pictograms are in the right place and legible.
3. Check the levels and/or amounts of lubricants for:
- gearbox oil (see par. 7.7.1)
- hydraulic oil if any (see par. 7.7.1)
USE AND OPERATION
CH. 6
Summary of Contents for MR
Page 99: ......