67
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 6 - Use and Operation
6.5
CHECKS TO BE PERFORMED WITH UNWOUND HOSE AND PRIOR TO STARTING IRRIGATION
1) Ensure the hose guide fork is aligned with the hose or slightly moved
towards the last wound coil.
This check must be performed with the hose completely unwound.
If this is not the case, act as follows:
- Take down the side casing covering the chain.
- Remove the chain's connecting link to make the hose guide bar free
to rotate.
- Rotate the hose guide bar to the right or left until the hose guide fork
is in the correct position.
- Fit the chain's connecting link back on.
- Fit the side casing covering the chain back on.
LH
RH
2A) For skid and 3-wheel trolleys (see ref.36, 37, 38, 39, 40 par.2.3.1)
ensure the cover on the bend of the hose at the head of the trolley is
screwed on.
2B) For skid and 3-wheel trolleys (see ref.41, 42 par.2.3.1) ensure the
cover is engaged and closed on the half-coupling at the end of the
hose on the trolley's head.
3) If the machine is equipped with a computer:
- check the length of the unwound hose on the display.
- set the required rain and time parameters for the type of crop to be irrigated.
(It is recommended to read the specifi c Manual to make these settings easier).
4) Connect the hose (see ref. 20 par.2.1) to the machine's water inlet (see ref. 14 par.2.1).
6) Prior to connecting the water piping to the machine, let a suffi cient amount of water fl ow out to allow any foreign matter that might clog the turbine
to be removed.
7) Connect the water supply pipe to the hose (see ref. 20 par.2.1).
8) Refer to the irrigation rate chart (see ref. 6 of chapter 9 ANNEXES) supplied with the machine to identify the most suitable hose retrieval speed.
Summary of Contents for MR
Page 99: ......