90
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 8 - Troubleshooting - Diagnostics - Solutions
Fault or
Inconvenience
Cause
Solution
The machine is not
stable
The front and/or rear
anchors might not have
adequate grip on the
ground.
Remove the hazard situation by acting as indicated in the danger provision at the
beginning of chapter 8
Stop hose reeling in by moving the lever on the gearbox in the RELEASE position (see
paragraph 2.6.1).
Adjust with increased strength the anchors' grip to the ground and move the lever back to the
WORK position (see paragraph 2.6.1).
The friction generated
between the unwound
hose and wet ground
and/or a certain type of
crop might abnormally
overload reaction on
the anchors.
Remove the hazard situation by acting as indicated in the danger provision at the
beginning of chapter 8
If the problem is caused by excessive soil wetness, wait for it to dry and possibly before
resuming work, it is recommended to run a rope underneath the entire unwound length of the
hose.
If the problem is connected to the soil as well as the special type of crop, proceed as above and
place pieces of wood underneath the hose at 10 ÷ 15 m gaps.
In the event the issue should be related to the computer or battery or internal combustion engine, or other trade components installed on the machine,
please refer to the relevant manual supplied with the machine for more details.
For situations not specifi ed in the specifi c documentation supplied, please contact the Manufacturer's T.S.C.
Summary of Contents for MR
Page 99: ......