CONNECTING THE MONITOR/DISPLAY
CONNECTING THE MONITOR/DISPLAY
CONNECTING THE MONITOR/DISPLAY
CONNECTING THE MONITOR/DISPLAY
CONNECTING THE MONITOR/DISPLAY
The 5420 supports both a CRT monitor and a flat panel display.
The programs CT.COM and FP.COM allow you to toggle between
displaying the monitor and the flat panel. The program SM.COM
allows you to display from the monitor and the flat panel simulta-
neously. However, this option is video BIOS/flat panel dependent
and may not work with every flat panel. These programs are
found on the 5420 Utility Disk along with other diagnostic and
configuration utilities.
Analog Monitor
1.
The DB–15 connector at J2 supports an analog VGA color or
monochrome monitor. Plug the cable supplied with your
monitor directly into J2.
Analog Connector: J2
Pin#
Function
1
Red
2
Green
3
Blue
4
NC
5
Digital Gnd
6
Analog Gnd
7
Analog Gnd
8
Analog Gnd
9
+5V safe
10
Digital Gnd
11
NC
12
NC
13
H Sync
14
V Sync
15
NC
2.
Make sure the video BIOS jumper is enabled — W2[1–2].
3.
Configure and program your Micro PC Control Card for use
with a video card and monitor. Refer to your Control Card’s
manual.
4.
Boot your Micro PC system.
5420 Super VGA Video Card – 8
Summary of Contents for 5420
