12
13
1. Attach pedal lever
a. Remove shoulder bolt/nut from 3 pivot link.
b. Place pedal lever through leg slot in rear shroud and attach it
to the 3 pivot link.
c. Fasten the bolt and nut until it is snug using 17mm socket and
wrench.
2. Place top cover
a. Place top cover on top of main housing—
don’t attach the
side screws; it is easier to lift the cover when installing
the console upright tube.
3. Install console upright
a. Attach all four 6mm hex head screws, engaging about 1/2 of
the threads to the upright mounting plate on the base.
b. Insert the console upright though the hole in the top shroud,
placing the upright plate over the bolts and sliding it forward
(away from the pedals).
c. Rotate top shroud 90° to access bolts.
d. Tighten the four 6mm hex key bolts attaching console upright
to frame.
e. Connect three wires on base frame to three wires at base of
console upright—
listen for a click to make sure it is a
positive connection.
f.
Use the three supplied zip ties to secure the cable. Push
the excess cable into the console upright tube.
4. Mount console to console upright tube
a. Attach plug from the top of the console upright tube to the
connection on the back of the console—
make sure it is a
positive connection.
b. Make sure excess cable is pushed into upright tube and not
pinched when console is attached.
c. Insert all 4 screws partially into the console back. Then tighten
all 4 screws.
