35
1-800-68-634
Octane Fitness Confidential
3.8
Software Update
Software updates for your Octane Fitness elliptical cross trainer are installed using a small handheld device called a
pocket programmer (Figure 3.12). To obtain a pocket programmer, contact Octane Fitness Customer Service.
1. Remove the four (4) screws securing the console to the mast plate (Figure 3.10); gently rest the console on the
stationary handlebars.
2. Position the pocket programmer so that the red stripe on the ribbon cable is on the right (Figure 3.12).
3. Insert the 6-pin black connector of the pocket programmer firmly into the 6-pin black slot on the back of the
console
(Figure 3.11)
.
4. The light on the pocket programmer will be yellow, indicating a proper connection (Figure 3.13). Press the button on
the front of the pocket programmer to begin the software update. When the software update is complete, the light
on the pocket programmer will be green.
5. Disconnect the pocket programmer from the back of the console.
6. Position the console on the mast plate. Insert four (4) screws through the mast plate and tighten to secure.
Ready
(Yellow Light)
Update Complete
(Green Light)
Figure 3.14
Figure 3.12
6-pin
Connector
Red line
