13
11. Plug in product
a. First, insert the plug into the product, located just below
the right roller track. Next, route the cable toward the wall
outlet. You can run it under the product to avoid seeing it
or tripping on the cable. Ensure that the cord will not be
pinched and become damaged. Plug the product into the
wall.
Note: There is no need to turn off your product
—your
Q47e/Q47ce was designed with an intelligent sleep
mode—a virtual off button. This eliminates the
need for an on/off switch. When your product is in
sleep mode, it uses very little power. Unplugging
your elliptical will not harm or erase My QuickStart
profiles.
10. Adjust levelers
a. Adjust all four levelers to make sure the product sits flat on
the floor. For a lower step up height, screw the rear levelers
into the rear stabilizer bracket. Then level the machine
using the front levelers.
b.
Tighten the leveler nut against the frame for each
leveler.
Note:
If you move your Q47e/Q47ce, you may need
to adjust the levelers to make sure your
product is level with the floor.
CAUTION
:
If the unit is not level, it may not function
properly.
9. install mast boot
a. Place the rubber mast boot (I) around the mast (B), covering
the open ends of the stationary handlebars.
b.
Tuck the ends of the mast boot (I) into the channels in the
access panel (D) just below the stationary handlebars.
