It is important to use a work area in which the vehicle is level and stable and, in this condition persists
for the whole installation phase.
Before installation, check the package contents.
Make sure that the supplied parts are all present and in good condition. Make sure that the
positioning
point of
OCTOBOX 4V VEDR
does not cause interference with the visual driving or with
the movement of the
rearview mirror.
Use the hardware components provided for the installation and the connection in order to
prevent
problems with the safety of the vehicle. Before positioning
OCTOBOX 4V VEDR
on the surface
of the windshield
or any surface clean the part. It recommends the use of specific products to remove
any traces of oily or
greasy substances. Do not use ethyl alcohol.
4.2 Installation OctoBox 4V
OCTOBOX 4V VEDR
is typically placed on the inside part of the front windshield view mirror.
When mounted on trucks, buses or other big vehicles, it is suggested to place the device at the center
of the windshield on the underside of the same.
In order to avoid repeated installations, carefully check the positioning point of
OCTOBOX 4V VEDR
, in
particular as it regards the non-interference with the driver's visibility and maneuverability of the
rearview mirror.
Mark the point of placement with a permanent marker.
Follow these steps to install:
0 Remove the backing from the double-sided tape mounting.
1 Place
OCTOBOX 4V VEDR
at the center of the windshield.
2 Check
OCTOBOX 4V VEDR
is centrally located and aligned horizontally with the windscreen, then
attach
OCTOBOX 4V VEDR
to the windshield.
3 Correct the angle of installation so that the system is aligned along the vertical axis.
4 Connect the power cable and check that the indicator LEDs POWER GPS and Wi-Fi assume the look on
(the indicator GPS status may remain flashing if the GPS signal is weak or absent).
Insert the micro SD card (sold separately)in the compartment of the body protected by safety
screw.
OCTOBOX 4V VEDR
can not operate without micro SD card.
To remove the card from the compartment housing press lightly on the accessible side of the board to
the center point of the camera body.
To insert the card you must accompany the same slot until it stops, and then gently press.
4.3
OCTOBOX 4V VEDR
cable positioning
The power cable of
OCTOBOX 4V VEDR
is integral with the body of the system.
