Basics
7
www.ocularrobotics.com
Ocular Robotics Pty Ltd
c)
Use fasteners appropriate for your camera to fasten the camera to the mount and
then tighten the socket screws attaching the mount to the base of the REV25
(Note – The screws used to attach the camera to the mount will need to be
loosened to focus the camera).
8.
Attach power and communications cables as appropriate for your camera.
2.4.2
RobotEye VISION REV25 System
Follow the steps below to set the REV25 system up for use on a computer with a
Windows or Linux operating system. The library version number and system IP address
shipped with your system should be noted on the supplied
Certificate
.
1.
Connect one end of the Ethernet cable to the network port on the PC or Switch.
Connect the other end to the REV25 Control Ethernet port (right-side Ethernet
connector). Refer to Figure 2.5.
2.
Connect another Ethernet cable to the REV25 Camera Ethernet port (left-side
Ethernet connector) and a PC or Switch.
Figure 2.5 Wiring and connections for the REV25 System
